100% opaque. This stunning paper is water-activated and pre-coated with adhesive. All you need to do to hang it is spray the wall and position your paper – there is no need to add paste. With a matte finish and a gorgeous lightly textured handle, this wallpaper offers a vibrant, permanent print of the highest quality, with sharp detail. It’s finish is tough, durable, and scratch-resistant. The certified ECO-print is odor-free and the water-based inks offer a sustainable alternative to mass-manufactured wallpapers

No paste required. Use a water spray bottle to spray the wall. Available from your local supermarket or hardware store.

Make sure that you have adequate lighting – so that you can inspect the material properly while you are hanging it and after it is in position.

Make sure that the area you are hanging wall covering in is well-ventilated and at least 12°C (55°F).

Clean your walls, using a detergent or sugar soap solution to remove any grease or surface marks. Allow to dry thoroughly before applying the wall covering.

Any holes, cracks or defects in the surface should be filled with good quality filler, smoothed out and allowed to dry. Remember: a dry surface is the right surface – so if you have to make repairs, be patient! Make sure your wall is completely dry before continuing.

New or unpainted walls must be sealed with a PVA or similar wall sealant. 

Wall needs to be sealed, either painted or at least one coat of primer applied to surface. When it’s time for a change, product can be easily removed from the wall in one piece.
Standard spray bottle can be used.

Fill spray bottle with tap water. Turn nozzle to spray function.

Recommend water to be applied at rate of 100ml per 1 sqm. Material can be re-positioned and re-aligned during first 10 minutes. Do not over-stretch the material.

To butt join drops of the wall covering, align the design top to bottom and work away from the butted edge with the same up and down motion using your soft sponge. You can also safely seal the butt joins using a small rubber roller along the join. Go easy with the roller, as overworking the join could cause damage to the edges.

Wipe over the surface with a damp sponge to remove any adhesive residue.

Should your Wallpaper become dirty, wipe clean with a sponge and mild, soapy water. Clean only when necessary, and use as little moisture as possible. Do not rub hard: the inks will not run, but a gap in the paper may become apparent.

Once the material has been applied to the wall, the product is deemed accepted and cannot be claimed as defective due to variations in mounting, adhesives, handling, and local environment (including humidity, heat, weathering or mold). Once you decide to cover the wall, we cannot be held liable for the alterations to the wall that are encountered when preparing or pasting your product. It is extremely rare that anything unusual should happen, but we are here to advise if there is anything you need to discuss after installation.

We will not be liable for damage to your wall or paintwork since prepping your wall for wallpaper is your responsibility. Make sure that your Wall covering is intact and has not been damaged in transit. Unpack carefully.